Pipe ID Clean out Made Easy With EXAIR’s Back Blow Safety Air Gun

In certain applications such as blowing chips or debris forward, out of a pipe or blind hole, may not be possible. The pipe may be long, making it impossible to push the debris all the way down the pipe, the other end of the pipe may not be open or there could be some process or area to which it is attached, that would become contaminated if debris were blown in that direction. In any of these scenarios, a Back Blow Nozzle is the right tool for the job. An array of holes located around the outside diameter of the Back Blow Nozzle head provides a powerful 360° airflow pattern that will pull and clear out any leftover coolant or chips ahead of it within a pipe from a machining or any other process.

EXAIR has three different size Back Blow Nozzles; the 1004SS (M4 x .5), the 1006SS (1/4 NPT), and the 1008SS (1” NPT). The 1004SS is recommended for use on pipes as small as ¼” and up to 1”. The 1006SS can be used for a wide range of pipe sizes, from 7/8” up to 4”. The 1008SS nozzle offers the greatest overall force for stubborn or sticky materials stuck to the inside diameter of the pipe. This nozzle is suitable for use in pipes ranging from 2”-16”. As the Back Blow Nozzle will be blowing chips and debris back out of the pipe towards the operator, it is always recommended that a Chip Shield is used. The strong, polycarbonate Chip Shield will keep an operator safe from flying debris and keep your company in compliance with OSHA directive 1910.242(b). For visual representation of the performance of the Back Blow Nozzle, take a look at this short video clip that demonstrates its use.

All of EXAIR’s Back Blow Nozzles are available with extensions. For the 1004SS we have extensions from 6”-36”, and from 12”-72” for the 1006SS and 1008SS. The Back Blow Nozzle can also be installed on our VariBlast, Soft Grip, Heavy Duty, and Super Blast Safety Air Guns. With such a wide range of available sizes and configurations, we can tackle just about any internal pipe cleaning application. If you have a process in your facility that may benefit from the use of one of these nozzles, give us a call and get one on order today!

Tyler Daniel, CCASS

Application Engineer
E-mail: TylerDaniel@exair.com
Twitter: @EXAIR_TD